Results 1 to 4 of 4

Thread: Short shifter heating up?

  1. #1
    Inactive Member AvanishV's Avatar
    Join Date
    June 16th, 1999
    Posts
    352
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    I noticed this the other day. After continued driving, my short shifter (the shifter itself, not the knob) will get hot. This ends up heating the shift bag a little bit. By the way, it's a tenzo short shifter.

    Is this common?

    ------------------
    1995 Integra GSR
    JR Supercharger (6 psi), HO fuel pump, RS*R Header, Thermal R&D Exhaust, Iceman Intake, Neuspeed Front Tower Bar, Type-R Rear Swaybar, Short Shifter, ST 1.3" drop springs

  2. #2
    Inactive Member Glenn's Avatar
    Join Date
    March 17th, 2002
    Posts
    75
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    It's very common. The lower part of the shifter (lever arm with ball bearings) is just above your exhaust pipe separated by less than an inch in some cars.

  3. #3
    Inactive Member green95gsr's Avatar
    Join Date
    February 25th, 2000
    Posts
    129
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    Hey, that is something I experience too. Actually, the shifter lever will get way too hot sometimes. I have a DC short shifter I'm not too happy with it because it is hard to shif. I don't know if it's a shifter problem or a tranny problem (I hope not). Anyway, I sure would like to find some cure for the hot lever. The nut just under the boot will actually burn you if you touch it with the tender part of the sides of your fingers! I think I'm going to try a piece of header blanket between the exhaust pipe and the mechanism.

    ------------------
    '96 GSR, JRSC 6 psi, Greddy Sp, Apex 4-2-1, Home made CAI w/K&N, Ground controls coil overs, Eibach, AGX, DC short shifter, more stuff on the way....

  4. #4
    Inactive Member Civic TSI's Avatar
    Join Date
    February 3rd, 2000
    Posts
    181
    Follows
    0
    Following
    0
    Mentioned
    0 Post(s)
    Tagged
    0 Thread(s)
    Quoted
    0 Post(s)

    Post

    There's a rubber piece around the shifter to protect it from heat of the exhaust. It's either misplace or broken.

    ------------------
    To 24 PSI, and beyond !
    HS Le Club

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •